--------
9 INSTALLATION 3. COLD WEATHER INSTALLATION (OPTIONAL) a. Check with your local building codes to see if a CFM reducer is an acceptable alternative
10 INSTALLATION DIAGRAM INSTALLATION DIAGRAM Fig. 2a Fig. 2bFig. 2c Fig. 2d
11 OPERATION & FEATURES OPERATION & FEATURES 1. EASY ACCESS CONTROL SWITCH (from left to right) a. Button 1 ON / DELAY SHUTOFF / OFF b. Bu
OPERATION & FEATURES 12 4. PUTTING IN THE OIL TRAY AND BAFFLE FILTERS a. Insert the oil tray into the unit at an angle and slide it down at the s
CLEANING & MAINTENANCE 13 CLEANING& MAINTENANCE WARNING!!! To prevent the possibility of a fire and explosion, do not use flammable liquids or
TROUBLESHOOTING 14 TROUBLESHOOTING WARNING!!! Check to make sure all power sources are disconnected before starting any troubleshooting. Safety gloves
PART LIST / REPLACEMENT 15 PART LIST / REPLACEMENT
PART LIST / REPLACEMENT 16 # Description # Description 1 Duct cover (optional) 9 Support panel 2 Hood bracket (optional) 10 Transformer 3 Hood bod
WARRANTY / CONTACT US 17 WARRANTY / CONTACT US LIMITED WARRANTY Windster Hoods Inc. warrants its product against defects in material or workmanship
WARRANTY / CONTACT US 18 WHAT IS NOT COVERED BY MANUFACTURE WARRANTY 1. Damages resulting from any of the following:a. Improper installation or mainte
1 TABLE OF CONTENTS Table of Contents Safety Information ... 2 3 Content Checklist ...
2 SAFETY INFORMATION SAFETY INFORMATION TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK, AND/OR INJURY OBSERVE THE FOLLOWING: Unit is intended for i
3 SAFETY INFORMATION TO REDUCE THE RISK OF FIRE, OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE. Regardless of hea
5 MEASUREMENTS
6 PREPARATION PREPARATION 1. BEFORE YOU START **DO NOT INSTALL IF DAMAGED** **RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED** a. Be sure you have al
7 PREPARATION e. For cabinet with recessed-bottom, use (2) 3 wood strips on both sides to balance the recession. Use (4) 1- screws to secure the woo
8 INSTALLATION INSTALLATION 1. UNDER CABINET INSTALLATION a. Make sure all preparation steps are completed. b. Feed the wires coming out of the hoo
Commentaires sur ces manuels